Brake system is important for the life safety of the driver, once on the road brake system failure, often a major traffic accident. So the owner should pay more attention to learning daily maintenance and troubleshooting methods of the braking system.

         Regular inspection, replace the brake fluid to clean and high quality of the brake fluid is the basic condition of braking system in good condition.

         Every month should check the brake fluid level, if a significant reduction in the brake fluid level with persistent, Ford VCM 2 you should go to 4 s shop for inspection. Other brake fluid to demand higher purity, if the impurities or mixed with air pollution, will seriously affect the braking effect and found that the brake fluid pollution should be set free liquid and rinse the entire system, and then use the new liquid filling of the main oil cylinder.

The color of the brake fluid will be warned. If the brake fluid color too deep, it may be down.

         Shaking the brakes should check the brake pads and brake disc vehicle body jitter, especially when the car brakes is always caused by the deformation of disk or pads. If after the replacement of brake pads and brake discs, fault eliminate temporarily; After a month or two, fault phenomena appeared again, check should be made for the lateral wheel, wheel deformation can also cause the brake wobble.

         Winter wash the car after the shake handshandle of hand brake principle is carefully with the power of pull hand brake lever, with brake line to convey its actions to the rear brake system. Ford VCM 2 After washing the car during the winter, water may enter the brake line, under the conditions of water use brake, and after long-term parking will be frozen water, at this point, even if the brake lever back, brake lines will not move. So, in winter after washing the car, should let the car driving distance, then stop to fit brake.