A servo motor is an engine that controls the operation of mechanical components in a servo system. It is an auxiliary motor indirect speed change device. The servo motor can control speed and position with high accuracy, and can convert voltage signals into torque and speed to drive the controlled object.

1. Servo motors can be used in places where they are exposed to water or oil droplets, but they are not completely waterproof or oil-proof. Therefore, servo motors should not be placed or used in water or oil-invaded environments.

2. If the servo motor is connected to a reduction gear, an oil seal should be added when using the servo motor to prevent the oil from the reduction gear from entering the servo motor

3. The cable of the servo motor should not be immersed in oil or water.

1. Ensure that the cable is not subjected to torque or vertical load due to external bending force or its own weight, especially at the cable outlet or connection.

2. In the case of servo motor movement, the cable (the one configured with the motor) should be firmly fixed to a stationary part (relative to the motor), and it should be extended with an additional cable installed in the cable support, so that the bending stress can be minimized.

1. Ensure that the radial and axial loads applied to the servo motor shaft during installation and operation are controlled within the specified values ​​of each model.

2. Be extremely careful when installing a rigid coupling, especially excessive bending loads may cause damage or wear to the shaft end and bearings

3. It is best to use a flexible coupling to keep the radial load below the allowable value. This is specially designed for servo motors with high mechanical strength.

1. When installing/removing the coupling component to the servo motor shaft end, do not hit the shaft end directly with a hammer. (If the hammer hits the shaft end directly, the encoder at the other end of the servo motor shaft will be damaged)

2. Try to align the shaft end to the best state (improper alignment may cause vibration or bearing damage).